Product Description:
RAM Billet Steel Flywheels
Cast flywheels are not explosion-proof and can be dangerous when used in high performance applications at higher rpm. RAM billet steel flywheels are recommended as replacements for factory-cast flywheels in high performance and racing vehicles. RAM billet steel flywheels are made in America and produced in house. All RAM flywheels are computer balanced within a ½ oz., surface ground which results an optimum mating surface, and are ready to run out of the box. They're better for launching heavier drag race cars and provide better drivability in street vehicles. SFI-approved, RAM billet steel flywheels are CNC-machined from certified materials.
Technical note: As they spin, heavy flywheels store more energy than lighter ones. Engine and gearing combinations that require more power or inertia to make the car launch without bogging the motor need heavier flywheels. However, heavier flywheels accelerate slower. Lighter flywheels create less inertia at launch, but accelerate quicker through the gears. When choosing a flywheel, you must consider the car's weight, operating rpm of the engine, and, most importantly, the gearing. Insufficient gearing will cause an engine with too light of a flywheel to "bog" on launch.
- Fits GM 10.5″ pattern
- 1 pc. Rear main seal
- 24 pounds
- External balance
- 153 tooth ring gear
- Meets SFI 1.1 specifications
- Made in the USA
- Pairs with RAM 88730 and RAM 92730
